Thinklogical Secure Console Server Manual Manual de usuario descargar pdf (Pagina 79)

S e c u r e C o n s o l e S e r v e r M a n u a l , R e v . K

, J u l y , 2 0 1 3

Page 79

#CBS1 Enables local and remote callback security.

#CBS2 Enables remote callback security only.

#CBS3 Disables callback security until local hangup or reset.

Command: #Pn Set 11-bit Parity

Values: n = 0 or 1

Default: 2

Description: #P0 No parity.

#P1 Odd parity.

#P2 Even parity.

Command: #Sx Enter Setup Password

Values: x= password (1–8 characters, case sensitive)

Default: MTSMODEM

Description: Enters the callback security setup password.

Command: #S=x Store Setup Password

Values: x= password (1–8 characters, case sensitive)

Default: MTSMODEM

Description: Stores a new callback security and remote configuration setup password.

S-Registers

Certain modem values, or parameters, are stored in memory locations called S-Registers. Use

the S command to read or to alter the contents of S-Registers (see previous section).

Unit Range Default Description

1 ring 0, 1–255 1

Sets the number of rings until the modem answers. ATS0=0 disables auto

answer completely.

1 ring 0–255 0 Counts the rings that have occurred.

decimal 0–127 43 (+) Sets ASCII code for the escape sequence character.

128–255 Values greater than 127 disable escape.

decimal 0–127 13 (^M) Sets the ASCII code for the carriage return character.

decimal 0–127 10 (^J) Sets the ASCII code for the line feed character.

decimal 0–32 8 (^H) Sets the ASCII code for the backspace character.

33–1 27 Values greater than 32 disable backspace.

seconds 2–65* 2*

Sets the time the modem waits after it goes off-hook before it begins to dial the

telephone number.

seconds 35-65* 50*

Sets the time the modem waits for a carrier signal before aborting a call. Also

sets the wait for silence time for the @ dial modifier.

seconds 0–65 2

Sets the length of a pause caused by a comma character in a dialing com-

mand.

decimal 0, 1–127 37 (%)

Sets ASCII code for remote configuration escape character. S9=0 disables

remote configuration.

S10

100 ms 1–254 20 Sets how long a carrier signal must be lost before the modem disconnects.

S11

1 ms 50–1 50* 95* Sets spacing and duration of dialing tones.

S28

decimal 0, 1–255 1 0 disables, 1–255 enables V.34 modulation.

S30

1 minute 0, 1–255 0

Sets the length of time that the modem waits before disconnecting when no

data is sent or received. A value of zero disables the timer. See also the \T

command

S35

decimal 0–1 1

0 disables, 1 enables the V.25 calling tone, which allows remote data/fax/voice

discrimination.

S36

decimal 0–7 7

Specifies the action to take in the event of a negotiation failure when error control

is selected. (See S48.)

S37

decimal 0–19 0

Sets the maximum V.34 “upstream” speed at which the modem attempts to

connect.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 89 90

Comentarios a estos manuales

Sin comentarios

Thinklogical Secure Console Server Manual Manual de usuario Pagina 79

Comentarios a estos manuales